CreatBot Brass Nozzle 0.4mm V2
zoom_in
  • CreatBot Brass Nozzle 0.4mm V2
  • CreatBot Brass Nozzle 0.4mm V2
keyboard_arrow_down

CreatBot Brass Nozzle 0.4mm V2

€27.90
Tax included

CreatBot Brass Nozzle 0.4mm V2

Quantity
check In Stock

  • Payment by Card, PayPal, Cash on Delivery  and payment at the store. Payment by Card, PayPal, Cash on Delivery and payment at the store.
  • Free shipping for order over 100€ in Greece Free shipping for order over 100€ in Greece
  • You are interested in mass markets and prices. Contact us You are interested in mass markets and prices. Contact us

Compatible with: CreatBot DX, DX Plus and DE

All nozzles from Creatbot are made from the best high-quality brass or steel (depending on type) and are completed in a state of the art factory. All nozzles are manufactured with a tolerance of less than ± 0.01 mm. This means that your filament will have a very smooth and clear surface while extruding which, of course, results in better prints.

The process of making a Creatbot nozzle begins with a selected high-quality material. When the material reaches the factory, there is first an optical inspection made of the material that are going to be used for each batch of nozzles. Then it´s time to clamp the material, in other words, make it into a long rod. In our process this only is done once, in many other (cheaper) cases, this process must be repeated several times, often as many as 3-4 times and yet you don´t get the same results.

After this process, the material goes through an ultrasonic cleaning bath and after that it is cleaned again and protected against surface oxidation.

The nozzle will now take shape with millimeter precision, the tolerance is less than ± 0.01 mm.

The process of removing sharp edges from the nozzles is a very important step as this makes up a big part of the result. If there is to much sharp edges left on the nozzle it will make the nozzle more prone to clog. So it´s essential that the nozzle is very smooth and clean before it is used. In every batch a few nozzles are selected and cut in half to make sure that every specification is met, and that the surface is in perfect condition.

Compatible with: CreatBot DX, DX Plus and DE

Marks/dots on Nozzle = Size

  • 0 = 0.20mm
  • 3 = 0.40mm
  • 4 = 0.60mm
  • 5 = 0.80mm
22770

Notify me when available

Related Products..

You May Also Like..