TMC 2100 Stepper Driver
zoom_in
  • TMC 2100 Stepper Driver
  • TMC 2100 Stepper Driver
keyboard_arrow_down

TMC 2100 Stepper Driver

€18.50
Tax included

The most silent stepper driver

Quantity
check Delivery in 4 to 10 days

  • Payment by Card, PayPal, Cash on Delivery  and payment at the store. Payment by Card, PayPal, Cash on Delivery and payment at the store.
  • Free shipping for order over 100€ in Greece Free shipping for order over 100€ in Greece
  • You are interested in mass markets and prices. Contact us You are interested in mass markets and prices. Contact us

Driver-IC: TMC2100, noiseless operation (in certain modes)

test

Motor voltage: 5 to 45VDC
Hardware compatible with Step Stick and Pololu A4988
1.25A RMS continuous current (equivalent to about 1,77A Imax)
Step Pulse/Direction interface with micro-step function (interpolation of up to 256 micro-steps)
The driver board is "upside down" mounted, with the chip and the potentiometer down. Very important to make sure Not mounting wrong. To allow this, the pinout is mirrored too.
The heat sink is mounted on the circuit board on the back. This is much better, because the heat is much better guided by the heat pipes of the board, than the thick plastic layer of the chip itself.
The best way to adjust the motor current, the voltage at Vref-Pin (0 - 2,5V)to measure and then adjust the potentiometer. The maximum continuous current is 1,25A (Irms) or 1,77A (Imax) and is determined by the 0,11Ω-sense resistor.
Formulas for calculating the values:
Irms = (Vref * 1.77A) / 2.5V
Irms = Vref * 0.71
Imax = 1.41 * Irms
Vref = (Irms * 2.5V) / 1.77A
Vref = Irms * 1.41
Vref = Imax

test

Σχετική εικόναg voltage: 8 V

Maximum operating voltage: 35 V

Continuous current per phase: 1 A

Maximum current per phase: 2 A (with cooling)

Minimum logic voltage: 3 V

Maximum logic voltage: 5.5 V

Microstep resolutions: full, 1/2, 1/4, 1/8, and 1/16

23775

Notify me when available

Related Products..

You May Also Like..